
L3Harris FAA Ground Stop Hits Close to Home in Rochester
The Short Version
- A router at an L3Harris facility in Arkansas triggered the November 13 FAA ground stop by sending approximately 1,000 connection requests every four to five seconds — far beyond what the FAA's communications network could absorb.
- L3Harris employs roughly 3,800 people in the Rochester area, making this national aviation infrastructure story a direct local one.
- HPE says its Juniper routers did not fail; investigators are focused on how the equipment was configured or installed, not the hardware itself.
- Transportation Secretary Duffy wants to replace L3Harris but can't — the company owns the existing FAA network infrastructure, and no contract cancellation is possible.
- The copper-to-fiber migration won't be complete until end of 2028, and Duffy is requesting $50 billion for a full communications infrastructure rebuild.
On November 13, flights stopped — not at one airport, but nationwide. The FAA determined on November 16 that the ground stop traced to a router at an L3Harris facility in El Dorado, Arkansas. For Rochester, that makes this a local story: L3Harris employs roughly 3,800 people in the area, making it one of the region's largest employers.
What Caused the FAA Ground Stop

What Caused the FAA Ground Stop
The router at the Arkansas site was sending approximately 1,000 connection requests every four to five seconds — far more than the FAA's communications network could absorb. A second router at another facility showed the same behavior. When investigators disconnected both, communications problems stabilized almost immediately.
Authorities confirmed no foreign cyberattack or intentional interference was involved. The disruption was a technical failure, not a security breach.
Rochester's L3Harris and the FAA Contract

Rochester's L3Harris and the FAA Contract
L3Harris manages the FAA's telecommunications infrastructure under contract, and was in the middle of migrating the network from copper lines to fiber optics when the November 13 incident occurred. The problem router was installed as part of that transition.
Both routers were transported to L3Harris headquarters in Florida for diagnostic testing. Engineers from the FAA, Juniper Networks, and Cisco are assisting the review. The company issued a statement through WXXI News: "We are supporting the FAA in its investigation to understand the conditions that led to the Nov. 13 ground stop of our nation's air travel."
What Investigators Are Trying to Determine

What Investigators Are Trying to Determine
Hewlett Packard Enterprise, which makes the Juniper routers, says its equipment "did not fail" and was operating as designed. That pushes the focus toward how the routers were configured or installed rather than a hardware defect.
Transportation Secretary Sean Duffy was direct: "This was an FAA system that didn't meet the moment. Our contractor didn't meet the moment. Or the equipment didn't meet the moment," he told reporters. He also made the government's bind plain:
"I want to get away from L3Harris and get to a new one, but they own the network. I can't cancel the network that they own."
— Transportation Secretary Sean Duffy, via WXXI News
A Modernization Project Years Behind Schedule

A Modernization Project Years Behind Schedule
The FAA operates approximately 60 Juniper routers across its air traffic communications network. The full copper-to-fiber transition isn't expected to be complete until the end of 2028, meaning the installation work that produced this failure is still years from finished.
Duffy is requesting $50 billion for a full FAA communications infrastructure rebuild. For the 3,800 Rochester-area residents who work at L3Harris, the contract is not in immediate jeopardy — the company owns the infrastructure — but the investigation's findings will shape what comes next. Both routers remain at the L3Harris Florida lab while testing continues.
Content ID: nXbFr74hbPREm6aQlWMqrEp7
See an error? Tell us.




Comments
Share with the Community